Hanging the Fan
REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly.
NOTE:
This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using the downrod with
b a l l a n d s o c k e t m o u n t i n g a n d t h e
"flushmount" installation. The "flushmount"
installation is recommended in rooms with
less than 8-feet ceilings or in areas where
additional space is desired from the floor to
the fan blades. When using the standard 4
1/2" downrod, the distance from the ceiling
to the bottom of the fan blades will be
approximately 12
inches.Once you have
selected which mounting system you will
use, proceed with the following instructions.
Where necessary, each section of the
i n s t r u c t i o n s w i l l n o t e t h e d i f f e r e n t
procedures to follow for the two types of
mounting.
1/2
4.
non-slotted screws and loosen the slotted
screws. This will enable you to remove
the hanger bracket. (Fig. 5)
. Pass the 120-volt supply wires through
the center hole in the ceiling hanger
bracket. (Fig. 6)
NOTE:
9. Align the holes at the bottom of the
downrod with the holes in the collar on
top of the motor housing. (Fig. 6A).
Carefully insert the hanger pin through
3. Loosen the two screws on the outlet box
in half way.
4. Attach the hanger bracket on the outlet
box by sliding the hanger bracket over the
screws provided with the outlet box.
5. Tighten the two screws on the outlet box
securely.
6
7. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly.
8. Route wires exiting from the top of the fan
motor through the coupling cover and
canopy ring. Make sure the slot openings
of the canopy ring are on top. Route the
wires through the canopy and then
through the ball/downrod assembly (Fig.
6A).
If a longer downrod is needed, take
out the screw located in the hanger ball,
lower the hanger ball and remove the pin,
remove all 3 pieces from the downrod and
assemble them onto the new longer
downrod before proceeding step 8. (The
longer downrod is available at any Home
Depot store).
t
Be
careful not to jam the pin against the
wiring inside the downrod. Insert the
locking pin through the hole in locked
position, as noted in the circle inset of
Fig. 6A.
10.
(Fig. 6A)
11.
he holes in the collar and downrod.
Tighten two set screws at top of the
fan motor collar firmly and evenly.
Place the downrod ball into the
hanger bracket socket. Rotate the
downrod ball until the groove of the
downrod ball lines up with the hook
of the hanger bracket. (This will help
balance the fan.)
Figure 5
Hanger
bracket
Ceiling
canopy
Screws
Canopy
ring
WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 9
COULD RESULT IN FAN LOOSENING
AND POSSIBLY FALLING.
STANDARD CEILING INSTALLATION
1. Remove the canopy ring from the canopy
by turning the ring clockwise until it
unlocks. (Fig. 5)
2. Remove the hanger bracket from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
