background image

13

HOMEDEPOT.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Troubleshooting

Problem

Possible Cause

Solution

The fan seems louder than
it should.

The CFM is too great.

Be sure the CFM rating on the fan matches the square footage of 
your room.

The damper is damaged or not working properly.

Check the damper to ensure it is opening and closing properly. If the 
damper has become damaged, please call Customer Service.

The bend in the duct is too close to the fan 
discharge.

Be sure you do not have any sharp bends in the duct closer than 
18 in. to the fan discharge.

The fan discharge is reduced to fit a smaller duct

Use the recommended size ducting to reduce fan noise.

The fan body is not attached securely.

Be sure the fan is securely attached to the ceiling joists.

The fan is not clearing 
the room.

There is insufficient airflow intake in the room. 

Be sure a door or window is slightly ajar or opened to allow adequate 

air flow. The fan is not able to draw out ot the room without enough 

airflow to draw front. 

There is insufficient CFM.

Be sure the CFM rating on the fan matches the requirements for 

your room size.
NOTE: Using a tissue is not the correct method for determining if the 
fan is operating properly. If the fan clears steam from the room 
within approximately 15 minutes of completing your shower, then 
the fan is operating properly.

Fan does not operate
when the switch is on

 A fuse may be blown or a circuit tripped.

Replace fuse or reset circuit breaker.

Connector plug from motor is not plugged in.

turn off power to unit. Remove Grill and plug motor into receptacle 
in housing. Restore power to unit.

Wiring is not connected properly.

Turn off power to unit. Check that all wires are connected.

Motor has stopped operating.

Replace motor.

Fan is operating, but

air moves slower than

normal.

Obstruction in the exhaust ducting

Check for any obstructions in the ducting. The most common are 

bird nests in the roof cap or wall cap where the fan exhausts to the 

outside.

Fan is operating
louder than normal

Motor is loose.

Turn off power to unit. Remove grill and check that all screws are 
fully tightened. Restore power to unit.

Fan blade is hitting housing of unit.

Call the Customer Service Team at 1-855-HD-HAMPTON or visit  

www.HomeDepot.com

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that may cause undesired operation. 

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate 

the equipment. 

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate 

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or 

more of the following measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

- Consult the dealer or an experienced radio/TV technician for help.

FCC compliance information is listed as below: 

Responsible party: Leedarson America, Inc.

Responsible party address: 300 Technology Court SE Suite 100, Smyrna, GA 30082 

Telephone number: (678) 293-8382

Содержание LDS-BF2002















Отзывы: