1
Use and Care Guide
LED MOTION SENSOR
PATH LIGHTS
PACKAGE CONTENTS
A –Lamp body x 1 B – Wire Connector(with 12 in. wire attached to lamp body) C –Ground Stake (6.53 in.) x1
Per assembly and Installation
1
Detect PIR deck lights pairing
2
Preliminary motion sensor and pairing test
-
If operating only one fixture, place the fixture in its permanent location.
- To operate multiple fixtures, please pair the fixtures before installation,
follow the PAIR steps below
□
Lift the plastic cover (1) by hand, and then slided the swith (2) to the
PIR.
□
There is a DIP switch on the top of fixture, there have 4 bottons on the
switch can be slided to up and down. The fixtures with the switch
bottons in the exactly same setting will be paired as a group . Groups
can be set freely (except "0000" and "1111").
□
When at PIR off mode (0000), fixture is at off status, will not pair.
□
When at PIR test mode (1111), fixture will turn on after detecting
motion whenever at day or night, then turn off after 3S of delay.
□
If pairing lost efficacy, slided the swith (2) to the OFF, and then slided
to PIR again.
What to know before intall
:
–Decide which PIR Deck Lights will be grouped (up to 10 fixtures).
–Open the plastic cover on back of each PIR Deck Light.
–Refer to the “Pairing via DIP Switch’’ Step to pair the deck lights.
–Close the plastic cover (to prevent water go inside fixture).
–When the gear is adjusted to "ON", it is "1"
-
Test the motion sensor function of a single deck light.
□
Connect path light into main power cord by wire connectors.
□
Stir 4 buttons up to “ON” (Mode 1111) to make deck light on
test mode.
□
Cover the PIR sensor with light blocking object, to do
preliminary function test.
□
Remove the light blocking object, this path light will be
powered on, this means that the single path light pairing
function works.
-
Test the pairing function of multiple deck lights.
□
Connect each path light into main power cord by wire
connectors (up to 10 deck lights).
□
Stir 4 buttons in any mode (except "0000" and "1111"), which
makes the path light enter the multi-lamp pairing test mode.
□
The mode of all path lights that need to be paired needs to be
set to the same.
□
Cover the PIR sensor with light blocking object to each path
lights to do preliminary function test.
□
Remove the light blocking object of one path light, this path
lights will be powered on. The rest of path lights in a group will
be sequentially powered on. This means function of motion
sensor and wirelessly link of path lights works.
General Notes
:
–When the transformer is turned off the fixture light will turn
off, then PIR function become active and converts to battery
power.
–PIR Function is only active after the sensor detects the
environmental brightness at less than 50LUX at night.
–When the sensor detects the environmental brightness of less
than 50LUX, plus PIR detects motion, the deck light will turn on
and stay on for 1 minute before turning off.
–When the sensor detects the environmental brightness higher
than 200LUX, after a 90 second delay time, deck light will turn
off. The purpose of setting 90 second delay is to prevent the
200LUX brightness caused by a flash of lightning or car light.
Item # 1007 891 901
Model # KXX1501LX-01
