Item #1001 492 874
Model #HD38609
Use and Care Guide
LOW VOLTAGE LED SUBMERSIBLE FLOOD LIGHT
Part
Description
Quantity
A
Base
1
B
Adjustment Screw
1
C
Submersible Lamp
1
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
2
Installation procedure
3
Running the landscape wire
CAUTION: Safe for outdoor operation
WARNING: RISK OF ELECTRIC SHOCK
WARNING: Use only in ponds and small decorative fountains where persons will
immerse no more than their hands and lower arms while the product is energized.
WARNING: DO NOT use in water intended for swimming, wading, immersion, or
bathing.
WARNING: All installer completed cable connections must be located outside of
pond or fountain.
WARNING: Low voltage circuit must be supplied by a power unit marked as
suitable for supplying submersible luminaires.
WARNING: Power unit must be supplied by a circuit protected by a ground fault
circuit interrupter (GFCI).
WARNING: Do not operate the luminaire fitting with a missing or damaged lens
or bulb protector.
□
Carefully remove the fixture from its protective packaging.
□
The submersible light is fully assembled.
□
The fixture is equipped with a base that will support the fixture.
However a weight like rocks or gravel must be
put on the support to keep the fixture underwater.
□
The U-shaped bracket will allow the fixture to be
swiveled up and down through 180˚.
□
When the desired position is obtained, it can be fixed by tightening
the adjustement screw (B).
□
Once the fixture is positioned, connect the cable (not included)
directly to the secondary circuit terminals on a power supply
approved for submersible fixtures.
□
Submerse before lighting.
WARNING: Install in accordance with all local codes and ordinances.
□
The landscape wire (not included) should run directly from the
light fixture to the power supply.
□
If the landscape wire is too long, cut it with a cable cutter
at the transformer end.
□
The landscape wire should be protected by routing it
close to proximity of a building, deck or fence.
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTION.
ETL LISTED UNDER MODEL # U000-1705
Please read and save these instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
A
B
C
NOTE: Water level in fountain/pond must be kept above fixture at all times.
Fixture must not be used when not fully submerged. FIXTURE SHOULD
NOT BE SUBMERGED DEEPER THAN 2 FT. OF WATER.
