1. To replace the remote control:
20
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Operation
Installing the batteries
□
□
□
□
□
□
□
□
NOTE: The battery will weaken with age and should be replaced
before leaking takes place as this will damage the remote
control. Dispose of the used battery properly and keep the
battery out of the reach of children.
Remove the battery cover by pressing on the arrow
and sliding the cover off.
Install two 1.5V AAA batteries (S).
Replace the battery cover on the remote control.
CAUTION: Do not use with a wall light dimmer switch.
Press and hold the ON/OFF button, turn on the power, pair the remote control with the fan. The pairing is successful when the
indicator flashes twice. If it fails, turn off the fan power and then turn on to re-pair.
S
NOTE : After the AC power is on, do not press any other button on
the remote control before pressing the " " button. Otherwise
the procedure will fail.
Should you desire to use another remote control unit with your
new fan, install one using the steps below:
Turn the main power source off to begin the pairing process.
Press and hold the button to enter the learning function.
Return the power to the unit, keep holding the button.
Within 15 seconds of turning the fan’s AC power 0N, once the
receiver has detected the set frequency, the down light of your fan,
if applicable, will blink twice. Please repeat the above steps if
there is no indication after 15 seconds.
A receiver can remember up to three remote controls. If a
fourth is used, the first would be deleted.
NOTE : The remote control can pair with multiple receivers
.
Make
sure no other receivers are operating during the learning process
.
Separate the fan power switches by approximately 7 meters
.
2. To pair the remote control:
