PAGE 3
PAGE 2
GREEN ONLY
GREEN AND RED
RED ONLY
TIME
30 SECONDS
1 MINUTES
3 MINUTES
SENSITIVITY
(SENS)
10 FEET
3 METERS
25 FEET
7 METERS
40 FEET
12 METERS
MANUAL OVERRIDE FEATURE
The Manual Override Feature allows the unit to be turned ON or OFF manually, bypassing the motion sensor.
NOTE:
The Manual Override Feature is only available if the lighting fixture is connected to a wall switch.
The Manual Override Feature only works at night.
MANUAL OVERRIDE:
To manually turn the unit ON, turn the wall switch OFF for 2 seconds and then ON again.
The floodlight will turn ON and remain ON until the wall switch is turned OFF.
If the light is left ON in the Manual Override mode through the night, the unit will
automatically turn OFF when daylight is detected and will reset to Automatic Operation.
RESETTING TO AUTOMATIC OPERATION:
To return the security light to automatic operation, turn the wall switch OFF and then back ON within 1 second.
The floodlight will turn off and stay off until motion is detected. Leave the wall switch in the ON position
to operate in automatic mode.
INSTALLING THE MOTION SENSOR
Continued from Page 1
STEP 3:
Rotate the motion sensor locking ring clockwise until snug.
Do not over tighten.
STEP 4:
Aim the motion sensor at the center of the desired detection area.
Be sure to space the motion sensor at least 1-1/2" from the lamp head(s).
STEP 5:
Turn the power back on at the main power panel.
Series 7811
Series 7818
TIME
CDS
SENS
RED LIGHT
GREEN LIGHT
RED LIGHT
GREEN LIGHT
Series 7828
TIME
CDS
SENS
RED LIGHT
GREEN LIGHT
RED LIGHT
GREEN LIGHT
IMPORTANT NOTE:
To prevent damage during shipment, the photocell (located at the bottom of the motion sensor)
is protected with a cover/sticker labeled as
CDS
. With the
CDS
sticker in place, the motion
sensor’s function and setting can be checked during the daytime. In order for the motion sensor
to work properly as intended, the
CDS
sticker must be removed.
ADJUSTING THE MOTION SENSOR CONTROLS
TIME:
Sets how long the light will stay on after the last motion is detected.
SENSITIVITY (SENS):
Sets sensitivity of the motion sensor. Generally, the sensitivity should be set at maximum.
Lower the sensitivity to reduce false triggering caused by small animals.
After the motion sensor has been installed and power is turned on, press the Time button and the Sensitivity (SENS) button
until the combination of LED lights that are lit corresponds with the desired settings. (Please see table below)
Optional CREATaLIGHT™
Accessories
Please contact your local CREATaLIGHT™ retailer for product availability.
• 110 Degree Detection Zone Motion Sensor – With integrated photocell (Series 7811)
• 180 Degree Detection Zone Motion Sensor – With integrated photocell (Series 7818)
• 240 Degree Detection Zone Motion Sensor – With integrated photocell (Series 7828)
• 180 Degree Detection Zone Motion Sensor/Transmitter – With Indoor Alarm (Series 7938)
• 180 Degree Detection Zone Remote Motion Sensor – With transmitter to activate another fixture within 100 feet (Series 7948)
QUESTIONS
For further assistance or for more information, please call 1-800-562-5625, 8 am – 5 pm (Pacific Time), Monday – Friday
Motion Sensor/Transmitter – With Indoor Alarm
Motion Sensor – 110º, 180º, or 240º
Motion Sensor/Transmitter – With Remote Sensor
1-1/2" 1-1/2"
1.5"
