6
6.Finishing the Installation
Step 1.
Remove 1 of 4 screws on the mounting bracket
and loosen other 3 screws.(Do not remove.) Remove
the motor assembly from J hook .Lift and place the key
holes on the mounting plate over the 3 screws
previously loosened from mounting bracket,turn the
mounting plate until it locks in place and no longer
turns.Secure by tightening the 3 screws previously
loosened and the one previously removed.(Figure 9)
Step 2.
Align large screwheads at mounting housing
with slotted holes in the mounting bracket.Turn the
mounting housing until it locks in place and no longer
turns.(Figure 10)
7.Blade Installation
Step 1. Attach the fan blades to the blade
holders using the
blade
screws and
fiber
washer provided,
tighten screws securely.
(Figure 11)
Step 2. Remove
10 screws from the bottom
motor.
Align motor holes to blade
bracket
and secure with screws
previously removed
from the motor
,
tighten screws securely.
Repeat procedure with remaining blade
assemblies
.
(Figure 11)
Mounting
Figure 10
Mounting bracket
Housing
Large Screwheads
Figure 9
Washers
Screw
Blades
Screw
Blade Bracket
Figure 11
Screws
NOTE
YOU MAY THINK THAT YOU HAVE TURNED THE
MOTOR HOUSING ENOUGH UPON FEELING IT
STOP WHEN TURNING IT THE FIRST TIME, BUT
THAT IS PROBABLY ONLY THE HALFWAY POINT
AND IT IS EXTREMELY IMPORTANT THAT YOU
M A K E S U R E T H AT Y O U T U R N T H E M O TO R
HOUSING ALL THE WAY TO ENSURE THAT THE
MOTOR HOUSING IS COMPLETELY SECURE. TO
DO THIS, WHEN YOU BEGIN TURNING THE
MOTOR HOUSING TWO MORE INCHES (TO THE
LEFT) SO THAT THE SCREWHEADS REACH THE
E N D O F E A C H S L O T T E D H O L E , T H E R E B Y
REMAINING SECURE.
Mounting plate
Mounting
bracket
Содержание Clarkston
Страница 1: ...SKU XXX XXX ...
Страница 2: ... by Hampton Bay Clarkston ...
Страница 15: ...SKU XXX XXX ...
Страница 16: ...por Hampton Bay Clarkston ...