4. Hanging the Fan
WARNING
FAILURE TO PROPERLY INSTALL LOCKING
PIN AS NOTED IN STEP 7 COULD RESULT
IN FAN LOOSENING AND POSSIBLY
FALLING.
Mounting
screws
(supplied with
outlet box)
Hook
Ceiling
mounting
plate
UL Listed
outlet box
Figure 6
120V Wires
Washers
Step
2
. Pass the 120-volt supply wires through the center
hole in the ceiling hanger bracket as shown in
(
Fig. 6
)
Step
3
. Secure the hanger bracket to the ceiling outlet box
with the screws and washers provided with your outlet
box.
(Fig. 6)
C H A N G I N G T H E D O W N R O D
(OPTIONAL)
NOTE
attached to the hanger ball. In addition you
have been provided with a 4½
"
downrod to
use if desired. If you choose to use the
4½"
downrod, perform the following steps:
1. Remove the hanger ball from the
6"
downrod by loosening the set screw at
t h e
t o p
o f
t h e
downrod which holds the hanger ball to
t
h
e
downrod.
2. Slide the hanger ball down the downrod
and remove the support pin.
3. Insert the support pin in the holes at the top of
the 4½" downrod and slide the hanger ball up
the 4½" downrod. Make sure the support pin
is properly seated in the grooves in the top of
the hanger ball.
4. Tighten the set screw firmly.
:
Your fan comes with a 6" downrod
Hanging the Fan
REMEMBER to turn off the power. Follow the steps
below to hang your fan properly:
Step
1
.
Uninstal
l
the hanger bracket from the canopy by
remove the screw
of
the
round
hole
and
loosen
the
screw
of
the
key
hole
on the bottom of the hanging
bracket in 1/4" from the screw head and turning the
canopy counter clockwise.(Fig
.
5)
Figure 5
Ceiling
mounting
plate
Ceiling
canopy
Screw
of
the
key
hole
Screw
of
the
round
hole
Figure 8
Scroll
Br ac ke t sc rews
The br ac ke t
Collar screws
Figure 7
Socket
Plug
The bracket
near the plug
Bracket screws
Scroll with collar
Step 4. There are three brackets on the upper fan
motor assembly, and one of them is near the plug.
Remove the 4 screws from the bracket near the plug.
Attach the scroll with collar to the bracket near the
plug by screws previously removed.(Fig.7) Do not
over tighten the 4 screws.Connect the socket from
the scroll with collar to the plug from the fan motor
assembly.(Fig.7) Remove the 4 screws on the
bracket,attach the scroll to the bracket by screws
previously removed.Do not over tighten the 4
screws. Remove the 2 screws on the collar, attach
the scroll to the collar by the screws previously
removed. Repeat with the remaining scroll.
Tighten all screws on the scrolls securely.(Fig. 8)
Содержание CF556A-H26
Страница 2: ......
