Assembly — Installing the Light Kit
16
11
Attaching the light kit to
the switch housing
□
Remove the three light kit mounting screws (HH)
from the 14W LED light kit (I) and keep these screws.
□
While holding the 14W LED light kit (I) under your fan
motor assembly (F), locate two single white and blue
wires in the switch housing labeled "FOR LIGHT".
Make the polarized plug connections:
- White to white
- Blue to black
□
Carefully push all wires back into the switch housing.
Install the light kit assembly (I) onto the switch
housing with the three light kit mounting screws (HH)
removed previously. Be sure to tighten all screws.
CAUTION:
Before starting the installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
12
Mounting the glass shade
□
Remove the plastic nut (II), glass cap (JJ) and
decorative nut (KK) from the 14W LED light kit (I).
□
While holding the glass shade (J), slip the pull chain
(VV) from the switch housing into the outside hole in
the glass shade (J).
□
Feed the pull chain (VV) from the light kit stem
through the eyelet in the glass shade (J).
□
Place the glass shade (J) over the light kit stem.
Secure the glass shade (J) with the plastic nut (II).
□
Fit the glass cap (JJ) onto the light kit stem, and then
slip the pull chain (VV) from the side hole in the glass
shade (J) through the hole on the side of the glass
cap (JJ).
□
Feed the pull chain (VV) from the light kit stem
through the decorative nut (KK), and then thread the
decorative nut (KK) securely. Do not overtighten.
HH
I
F
VV
J
I
F
VV
JJ
II
KK
