Hanging the Fan
REMEMBER
to turn off the power. Follow
the steps below to hang your fan properly:
Step 1.
Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise. (Fig.4)
Step 2.
Remove the hanger bracket from the
canopy by loosening the two screws on the
bottom of the hanging bracket a half turn from
the screw head and turning the canopy counter
clockwise. (Figure 4)
Step 3
. Remove the hanger pin, lock pin and
set screws from the top of the motor assembly.
(Fig. 5)
Step 4.
Route wires exiting from the top of the
fan motor through the collar cover, canopy
cover, canopy and then through the ball /
downrod. (Fig. 5)
Step 5.
Align the holes at the bottom of the
downrod with the holes in the collar on top of
the motor housing (Fig.5). Carefully insert the
hanger pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the downrod. Insert the
locking
4.
CAUTION
Remove the 3 motor support plate, discard the
motor support plate.
Step 6.
Tighten two set screws on top of the fan
motor firmly (Figure 5)
Step 7.
Install the hanger bracket to the outlet
box; be sure to align the holes in the hanger
bracket with the post holes in the outlet box and
secure with screws and washers provided by the
outlet box.(Figure 6)
Step 8.
Hanging the assembled fan onto the
mounting bracket, place the downrod ball into
the mounting bracket. Rotate fan until the slot
of the downrod ball locks into the tab of the
mounting bracket. (Figure 7)
Step 9.
Secure the safety cable to the building
structure as shown in Fig.7
Step 10.
Connecting the wires (see making the
electrical connections)
WARNING
FAILURE TO PROPERLY INSTALL LOCKING
PIN AS NOTED IN STEP 5 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
pin through the hole near the end of the hanger
pin until it snaps into its locked position, as
noted in the circle inset of Fig. 5.
Figure 4
Hanger
bracket
Ceiling
canopy
Canopy
cover
Figure 5
Motor wires
Ball/downrod
assembly
Hanger pin
Locking pin
Collar cover
Downrod
Canopy
Canopy cover
Set screws
