WARNING: HOOK UP IN "SERIES ONLY" DO NOT CONNECT THE HOT AND
NEUTRAL WIRES OF ELECTRIC CIRCUIT TO THE TRANSMITTER WALL
SWITCH - DAMAGE TO THE SWITCH AND POSSIBLE FIRE COULD OCCUR.
Step 1.
Remove the existing wall plate and switch from the wall junction box.
Step 2.
Step 3.
(Fig.
) Carefully tuck the wire connections inside the junction box. Secure the wall
transmitter with the two screws provided. Attach the wall plate over the wall transmitter and
secure with the two screws provided.
Make the electrical connections as shown in (Fig. 11). If your outlet box has a ground
wire (green or bare copper) connect the wall transmitter's ground wire to it; otherwise
connect the wall transmitter's ground wire directly to one of the screws from the outlet box.
12
Figure 12
REMEMBER to Shut the Power Off at the Circuit Breaker or Fuse Box.
7.
Installing the Wall Transmitter
Figure 13
Outlet box
Hanger
bracket
Canopy
Canopy
cover
Screws
Finishing the Installation
Step 1.
Tuck connections neatly into ceiling
outlet box.
Step 2.
Slide the canopy up to ceiling and over
the 2 screws on the hanger bracket. Rotate
canopy clockwise. Next, while holding the
canopy with one hand, slide the canopy cover
over the screws and rotate clockwise until
tight.
Note:
adjust the canopy screws as
necessary until the canopy and canopy cover
are snug. (Fig. 13)
WARNING
Make sure the notch on the hanging bracket
properly sits in the groove in the hanger
ball before attaching the canopy to the
bracket by turning the housing until it
drops into place.
