12
Operation (continued)
4
Using a long match/lighter to light
WARNING:
Lava rocks can become very hot. DO NOT
touch unless they are completely cooled.
□
Connect the propane (LP) cylinder (see step 5 in the Assembly
section).
□
Before lighting, remove the glass and move the lava rocks to
allow access to the burner.
□
Locate the burner control knob and make sure it is in the “OFF”
position.
□
Wearing heat resistant gloves, position a long lit match or lit
lighter close to the burner ports. DO NOT lean over the burner
while lighting.
□
Push and turn the control knob to the “LOW” position. The burner
should light within 5 seconds.
□
If the burner does not light, turn the burner control knob to “OFF”
position, wait 5 minutes and repeat the lighting procedure. If the
burner still will not light, refer to the Troubleshooting section.
□
Flame height can be changed by adjusting the burner control
knob between the HI and LO (low) positions.
□
Always check the burner flames periodically to ensure proper
operation. Flames should be mostly yellow with some blue for
best performance. (See diagram on previous page)
5
Performing a visual check
□
Prior to each use, check the hose and valve for excessive
wear, abrasions or any damage.
6
Extinguishing the fire
□
Push and turn the burner control knob to the “OFF” position
and close the LP tank valve.
□
Disconnect the regulator from the LP tank to close the gas
supply when not in use.
□
Make sure that the unit is completely cooled before
touching any of the components or putting on the cover.
BURNER TUBE
ORFICE
METAL FLEX
TUBE
REGULATOR
HOSE
OFF
LP TANK
