4
Assembly
1
Setting up the frame
□
Stand the frame (A) upright. Starting at the corners, with a partner
standing on the opposite side, grasp the two outer legs and
slightly lift the frame (A) off of the ground and step backward
stopping at full arm’s length.
2
Attaching the canopy
□
Unfold the canopy (B). Place the canopy (B) over the top of the
frame (A). Use the hook and loop straps to secure each corner of
the canopy (B) to the frame (A) .
3
Expanding the frame
□
Each partner should then grasp the bottom rails of the middle
frame section (cross beam) where it forms a diamond. Lift the
frame (A) slightly off the ground and slowly walk backward until
the frame (A) is fully extended.
4
Extending the corner rib
□
Engage the slider at each corner of the frame (A) by pushing up the
slider with one hand while holding down the top of the leg with the
other hand. Repeat this step at the remaining corners.
NOTE:
The canopy and frame are shipped unattached to
avoid damage. First time set-up requires that the canopy be
attached to the frame. Once the canopy is permanently attached,
set up and take down are easily accomplished within seconds.
IMPORTANT:
Please do not use too much force during
set-up.
A
B
A
A
A
WARNING:
backward to hard as this may result in the bending of cross
beams.
Grab here to open
