3 ea Wire
Nuts (#18)
2 ea Bracket Mounting
Screws (#13)
INSTALLATION INSTRUCTIONS:
PARTS INCLUDED FOR INSTALLATION (parts are not to
scale):
1. Thread the Hex Nut (#12) onto the Nipple (#14). Thread the Nipple (#14) into the center hole of the
Mounting Bracket (#11). Do not tighten the Hex Nut (#12) at this time.
2. Pull the power supply wires out from the Outlet Box (#9), and mount the Mounting Bracket (#11) to the
Outlet Box (#9), using the Bracket Mounting Screws (#13).
3. Attach the Black Supply Wire (#10) to the Black Fixture Wire (#17) and the White Supply Wire (#21) to
the White Fixture Wire (#18) using Wire Nuts (#19). Connect the Fixture Ground Wire (#16) and the
Supply Ground Wire (#20) together using a Wire Nut (#19). Wrap all wire connections with electrical
tape for a more secure connection.
Note: If you have electrical questions, consult your local electrical
code for approved grounding methods.
4. Carefully tuck all Wires and Wire Nuts (#19) into the Outlet Box (#9). Place the Wall Plate (#15) (of the
Main Fixture Body (#5)) over the Outlet Box (#9), flush against the wall surface, making sure the Nipple
(#14) feeds through the hole of the Wall Plate (#15). Adjust the Nipple (#14) so that it protrudes about
¼ inch from the surface of the Wall Plate (#15). Remover the Wall Plate from the wall and tighten the
Hex Nut (#12) against the Mounting Bracket (#11). Replace the Wall Plate (#15) over the Outlet Box
(#9) and thread the Thumb Screw (#6) onto the Nipple (#14) to secure the Wall Plate (#15) against the
wall.
5. After installing the fixture, caulk upper 2/3 of the Wall Plate (#15) to mounting surface. Leave bottom
1/3 un-caulked for drainage of any water that might leak into the enclosure. The manufacturer
recommends a non-drying exterior caulking material. A good example is a clear silicone rubber sealant
for exterior use.
6. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the light switch on to
activate the fixture.
1 ea Mounting
Bracket (#11)
1 ea Nipple (#14)
1 ea Hex
Nut (#12)
1 ea Thumb
Screw (#6)
1 ea Main Fixture
Body (#5)
Page 7
