5 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
installation 2
1
Open the fixture
□
Open the lens (A) from the fixture base (B) by screwdriver,
and disconnect the connector between PCB and the driver.
2
Drilling out the holes
□
Drill out the mark points in the fixture base (B) according
with the mounted J-box holes.
3
Fixing the fixture base (B)
□
Put the Gasket (EE) on the back of fixture base (B).
□
Connect the AC wires and the driver wires by wire nut (BB).
□
Mount the fixture base (B) into the j-box with fix screw (DD).
note:
AC wires should go through one of the 5
conduit entry holes on the fixture base (B)
.
4
Assemble the lamp cover
□
Assemble the lens (A) with the fixture base (B) after
connecting the connector of PCB and driver. Then tighten
with lens screws.
□
Apply silicone sealant (not included) between the fixture
and the wall.
Conduit entry holes
BB
B
DD
EE
B
B
Lens screw
Silicone sealant (not
included)
A
Φ
0.2in.
(5mm)
A
B
B
Mark points
Connector
Connector
