5.
Figure 6
Hanger
bracket
Ceiling
canopy
Canopy
cover
Mounting
screws
(supplied with
electrical box)
Hook
Hanger
bracket
UL Listed
electrial
box
Figure 7
120V Wires
Washers
Figure 8
Motor collar
Collar cover
Pin in
locked
position
Motor wires
Ball/downrod
assembly
Ceiling
canopy
Tighten screws
firmly
Hole
Reversible
switch
Locking pin
Canopy
cover
Decorative
scroll
(Can not be
used with
4 -1/2" downrod)
Hanger pin
Hanging the Fan
REMEMBER
to turn off the power. Follow the
steps below to hang your fan properly:
Step 1.
Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 6)
Step 2.
Remove the hanger bracket from the
canopy by loosening the two screws on the
bottom of the hanging bracket
from
the screw head and turning the canopy counter
clockwise.(Fig, 6)
Step 3.
Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 7.
Step 4.
Secure the hanger bracket to the ceiling
outlet box with the screws and washers
provided with your outlet box.
Step 5
. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly.
Step 6.
Route wires exiting from the top of the
fan motor through the collar cover, decorative
scroll, canopy cover, canopy and then through
the ball / downrod. (Fig. 8)
collar cover
collar
(Fig. 8)
a half turn
NOTE:
When installing the
onto
the
, be sure the reversible switch and
hole on collar cover are aligned.
WARNING
FAILURE TO PROPERLY INSTALL LOCKING PIN
AS NOTED IN STEP 7 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Step 8.
Tighten two set screws on top of the
fan motor firmly. (Figure 8)
Step 9.
Place the downrod ball into the hanger
bracket socket.
Step 7.
Align the holes at the bottom of the
downrod with the holes in the collar on top of
the motor housing (Fig.8). Carefully insert the
hanger pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the downrod. Insert the
locking pin through the hole near the end of
the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 8.
