REMEMBER:
To disconnect the power. The fan blades must be already
attached to the fan.
Your fan and light kit though pre-wired have been disassembled at the factory
to ease in shipping. Please follow these steps to complete the installation of
your fan and light.
TO REDUCE THE RISK OF FIRE DO NOT EXCEED
MAXIMUM WATTAGE RATING.
Step 1.
Remove the 1 of 3 screws from the mounting plate and keep it for
future use. Loosen the other 2 screws (Do not remove)
Step 2.
Raise and hold the light kit close to the mounting plate and proceed to
do the wire connections. Connect the white wire connectors from the light kit
and fan, follow the same procedure with the black wire connectors. (Fig. 19)
Step 3.
Tuck connections neatly into mounting plate,
place the key holes on
the light kit over the 2 screws previously loosened from the mounting plate,
turn light kit until it locks in place at the narrow section of the key holes.
secure by tightening the 2 screws previously loosened and the one previously
removed. (Fig. 19)
Step 4.
Install 3 x 40W
bulbs (included). (Fig. 19)
Step 5.
Place glass shade over the light kit and secure it with the decorative
nut provided. DO NOT OVER TIGHTEN.
(Fig. 19)
candelabra
Figure 19
Bulbs
Mounting plate
Glass shade
Screws
Connection plugs
Light kit
Decorative nut
11. Installing the Light Kit
