Attaching the Fan
Blades
Step 1
Attach blades to blade brackets using
three screws and fiber washers as shown in
Figure 12. Start a screw into the bracket, do not
tighten. Repeat for the 2 remaining screws and
washers.
Step 2
Tighten each screw securely starting
with the center screw. Make sure the blade is
straight.
7.
All blades are grouped by weight. Because
natural woods very in density, the fan may
wobble even though the blades are weight
matched.
The following procedure should correct
most fan wobble. Check after each step.
1. Check that all blade and blade bracket
screws are secure.
2. Most fan wobble problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling
above the tip of one of the blades. Measure
this distance as shown in Figure 14. Rotate
the fan until the next blade is positioned for
measurement. Repeat for each blade. The
distance should be equal within 1/8".
If all blade levels are not equal, you can
adjust the blade level with the following
procedure.
Fiber
washer
Blade
bracket
Figure 12
Blade
Screws
Figure 11
Outlet box
Hanger
bracket
Canopy
Canopy
cover
Screws
Step 3
Fasten blade assemblies to the
motor using the screws already installed
in the motor housing. (Figure 13)
Step 4
Install an optional light kit if you
wish. Follow the instructions included
with the kit.
Motor
Blade Bracket
Figure 13
