REMEMBER
to turn off the power.
Follow the steps below to hang your fan
properly:
Step 1
. Secure the hanger bracket to the
ceiling outlet box using screws included
w i t h y o u r o u t l e t b o x , l o c k w a s h e r s
included with the fan. (Fig.5)
Step 2.
Loosen the two set screws and
remove the hitch pin and lock pin in the top
coupling of the motor assembly. (Fig. 6)
Step 3.
Remove hanger ball from downrod
a s s e m b l y b y l o o s e n i n g s e t s c r e w,
removing the cross pin, and sliding ball off
rod. (Fig.7)
Step 4.
Carefully feed fan wires up
through the downrod. (Fig. 8) Thread the
rod into the coupling. Next line up holes
and replace lock pin and hitch pin. Tighten
set screws.
Step 5.
Slip coupling cover, canopy cover
a n d c a n o p y o n t o d o w n r o d . ( F i g . 9 )
Carefully reinstall hanger ball onto rod
being sure that cross pin is in correct
position, set screws are tighten and wires
are not twisted.
Step 6.
Now lift motor assembly into
position and place hanger ball into hanger
bracket. Rotate until the check groove has
dropped into the registration slot and seats
firmly. (Fig. 10) Rod should not rotate if
this is done correctly.
Outlet box
Hanger bracket
Cross pin
Hanger
ball
Downrod
Downrod
Supply
wires
Figure 5
Figure 7
Figure 8
Figure 6
Figure 9
Figure 10
Registration
slot
Downrod
Coupling
*Omit coupling
cover when using
the minimum-length
downrod
cover
Canopy
Canopy cover
Set screws
Hitch pin
Lock pin
Hitch
pin
Lock
pin
Set
screws
Hanger ball
Hanging the Fan 4.