3.
Arrange the remaining two poles at each end. Push
down on the spring pins while pushing the poles into place
until the spring pins on the foot brackets exit through the
holes and lock into place.
4.
Place the pole end caps (w/holes) on the end poles
aligning the holes prior to pressing them down on the
pole.
5.
Insert the S hooks at each end cap. This is done by
inserting the hook perpendicular to the pole and turning it
to align with the pole.
6.
Using the chain provided with your hammock, hang
your hammock tightly on the S hooks and sit into the
hammock slowly. Your hammock will stretch and you
may experience bottoming-out initially.
Take extreme
care when sitting in the hammock for the first time.
Once
this initial stretching occurs, you will want to tighten the
hammock chains. Repeat this until a comfortable height
is reached;
always using care when sitting in an
untightened hammock.
CAUTION!! CAUTION!!
WARNING: DO NOT EXCEED LOAD LIMIT OF 600 LBS.
Do not drag or pull your hammock stand
when moving or adjusting.
ALWAYS lift from both ends.
If a wheel kit, purchased separately, is
installed, you may lift and move from the
opposite end from the wheels.
NEVER drag or pull your hammock stand
even when wheels are installed.
After any moving or adjusting of your
hammock stand, ALWAYS inspect to make
sure the spring pins are properly inserted.
Failure to do so may result in the hammock
stand collapsing upon use.
CAUTION! CAUTION!
Stands should be examined periodically to
ensure that:
- Each welded joint is fully intact.
- There are no missing caps (rust protection).
- There is no excessive rust.
3.
Arrange the remaining two poles at each end. Push
down on the spring pins while pushing the poles into place
until the spring pins on the foot brackets exit through the
holes and lock into place.
4.
Place the pole end caps (w/holes) on the end poles
aligning the holes prior to pressing them down on the
pole.
5.
Insert the S hooks at each end cap. This is done by
inserting the hook perpendicular to the pole and turning it
to align with the pole.
6.
Using the chain provided with your hammock, hang
your hammock tightly on the S hooks and sit into the
hammock slowly. Your hammock will stretch and you
may experience bottoming-out initially.
Take extreme
care when sitting in the hammock for the first time.
Once
this initial stretching occurs, you will want to tighten the
hammock chains. Repeat this until a comfortable height
is reached;
always using care when sitting in an
untightened hammock.
CAUTION!! CAUTION!!
WARNING: DO NOT EXCEED LOAD LIMIT OF 600 LBS.
5059SP/100SP
J00 P.2
Do not drag or pull your hammock stand
when moving or adjusting.
ALWAYS lift from both ends.
If a wheel kit, purchased separately, is
installed, you may lift and move from the
opposite end from the wheels.
NEVER drag or pull your hammock stand
even when wheels are installed.
After any moving or adjusting of your
hammock stand, ALWAYS inspect to make
sure the spring pins are properly inserted.
Failure to do so may result in the hammock
stand collapsing upon use.
CAUTION! CAUTION!
Stands should be examined periodically to
ensure that:
- Each welded joint is fully intact.
- There are no missing caps (rust protection).
- There is no excessive rust.
5059SP/100SP
J00 P.2
WARRANTY INFORMATION:
Products of The HammockSource are guaranteed to be
free of defects in workmanship and materials for up to
one year after the purchase date. Prolonged exposure
to weather conditions including snow, rain, and
humidity are not covered under the warranty nor is
damage caused by normal wear, mildew, improper
care including storage, maintenance, and installation.
If an item is found to be defective within one year of its
purchase, it will be replaced without charge upon the
return of the unit accompanied by a sales receipt. A
Return Authoriztion is needed for return and may be
obtained by contacting 800.334.1078.
WARRANTY INFORMATION:
Products of The HammockSource are guaranteed to be
free of defects in workmanship and materials for up to
one year after the purchase date. Prolonged exposure
to weather conditions including snow, rain, and
humidity are not covered under the warranty nor is
damage caused by normal wear, mildew, improper
care including storage, maintenance, and installation.
If an item is found to be defective within one year of its
purchase, it will be replaced without charge upon the
return of the unit accompanied by a sales receipt. A
Return Authorization is needed for return and may be
obtained by contacting 800.334.1078.
