Hammerhead Charger 48V, Руководство оператора

Страница: 21 / 55

Hammerhead Charger Electric Vehicle Operator’s Manual Page 20
REPAIR
To reduce the possibility of severe injury or death from a vehicle falling from a
jack:
Be sure the vehicle is on a firm and level surface.
Never get under a vehicle while it is supported by a jack.
Use jack stands and test the stability of the vehicle on the stands
Always place chocks in front and behind the wheels not being raised.
Use extreme care since the vehicle is extremely unstable during the lifting process.
WHEELS AND TIRES
Use caution when inflating tires. Due to the low volume of the small tires, over
inflation can occur in seconds. Over inflation could cause the tire to separate from
the wheel or cause the tire to explode.
Tire inflation should be determined by the condition of the terrain. See GENERAL
SPECIFICATIONS section for recommended tire inflation pressure. For outdoor
applications with major use on grassy areas, the following should be considered.
On hard turf, it is desirable to have a slightly higher inflation pressure. On very soft
turf, a lower pressure reduces the possible of tire cutting into the turf. For vehicles
being used on paved or hard surfaces, tire inflation pressure should be in the higher
allowable range, but under no circumstances should inflation pressure be higher
than recommended on the tire sidewall. All four tires should have the same
pressure for optimum handling characteristics. Be sure to install the valve dust cap
after checking or inflating.
The vehicle is fitted with low pressure tubeless tires mounted on one piece rims;
therefore, the most cost effective way to repair a puncture in the thread is to use a
commercial tire plug.
FUSE REPLACEMENT
To replace fuses, locate the fuse block under the bench seat. Pull out old fuse and
replace with new fuse. Fuses are available from local authorized repair center.