Hammerbacher VXBHM, Руководство по эксплуатации, Страница: 57 / 124

XMST 57
8.2 Other errors or faults:
Fault Possible cause Measure
Desk is moving more
slowly than normal
Permitted total load of
approx. 80 kg exceeded.
Reduce or remove load
Desk only drives down
slowly
New initialisation necessary
for the controls
Carry out RESET , as reset following power down,
re-initialisation)
Lift or lower process is
not reacting
Foreign bodies or dirt
blocking the area of the
telescopic pole
Remove foreign body / dirt
No or deficient power supply Check cable connections and power supply.
(Fuse on building side)
Missing or loose connection
to the drives or side sections
Check plug connections on the drives and the
motor cable on the controls and reinstate as
necessary.
Missing connection to the
control panel
Check plug connection on the controls and
reinstate as necessary
Defective drive Contact the manufacturer .
Defective motor controls Contact the manufacturer .
Defective operating panel Exchange the
operating panel
Desk only drives
upwards or downwards
or
Desk moves in jolts
downwards
Loss of information from the
control
• Disconnect from mains
• Re-connect the same
Carry out RESET , as reset following power down,
reinitialisation)
Defective drive Contact the manufacturer .
Defective motor control
Tensions exist because of
incorrect assembly
• Release the screws
• Drive to the top position
• Drive downwards
• Tighten screws
Instability of the desk Incorrectly inserted and fixed
plate traverse
Loose screws
Desk only drives briefly
to one side and then
stops
Missing or loose connection
to the side sections / drives
Check the plug connections on the drives and
on the control – reinstate if necessary
Defective drive Contact the manufacturer .
Unusual noises Telescopic pole is blocked by
dirt or foreign bodies
Stop the lifting or lowering process immediately
Remove the dirt of foreign bodies
One-sided or uneven
lifting or lowering
process
Control error Contact the manufacturer .
One-sided heavy load Remove or centre the load
Drive the desk upwards or downwards until it
stops automatically