28
!
"
Y
X
Y>X
Y<X
X1
X2
X1=X2=18 mm
!
"
#
#
"
!
Bandsaw
N2-35
7.2.4 Assembly - Rip fence
Setting the rip fence:
Move the rip fence to the left.
Measure the distance Y and X (Distance between
stop ruler and table groove).
The values X and Y must be equal.
Loosen the right nut.
The angle can be adjusted by twisting the adjusting
screw.
Y > X :turn - Anti-clockwise
Y < X :turn - Clockwise
Counter the right nut again.
Check the setting and readjust if necessary.
!
Rip fence
"
Nut - Right
#
Adjusting screw
Fig. 7-9: Setting the rip fence
Fig. 7-8: Height adjustment - Fence rail
Use a nut to mount the fence rail to the machine ta-
ble.
Slide the premounted fence onto the track.
!
Nut
"
Fence rail
Height adjustment - Fence rail:
Adjust the distance:
18
mm
(This setting has to be exact.)
Loosen the lock nuts.
Place a 90° angle at the front edge of the table.
Adjust the distance X1.
Turn the setting nut by hand.
Adjust the distance X2.
Tighten the lock nuts.
Check the setting and readjust if necessary.
!
Locking nut
"
90°- Angle
#
Fence rail
Fig. 7-7: Rip fence
Setup and installation
Содержание N2-35
