Hammer BLADE 2 PRO, Руководство пользователя

Страница: 11 / 39

© 2018 mPTech . All rights reserved. HAMMER BLADE 2 PRO
11
7.2 Installation of the memory card
To insert the memory card correctly one has to:
•
Switch off the phone.
• Use the supplied tool to open (insert the tip energetically into the hole) and
slide out the card tray (9).
• Insert the memory card into the slot as shown in the picture below (instead
of the nanoSIM1 card).
• Gently and carefully slide the card tray.
Use only memory cards recommended by the manufacturer. Pay attention to
the selection of the proper format-the microSD card, capacity and type/class.
Incompatible memory cards may damage the device and cause the stored data to
be destroyed as well. Incompatibility of memory card can be caused, among others,
by an incorrect card format (required format microSD) or an unsupported card
capacity - above the value recommended by the manufacturer.
7.3 Charging the battery
Charge the battery before the first use. The battery should be charged by the
attached charger or another charger, intended for this type of equipment. If in
doubt contact the seller or manufacturer service. Use only chargers and wires
recommended by the manufacturer. Using incompatible chargers or cables can
cause explosion of the battery or damage to your device.
When the battery is near a complete discharge, the notification is displayed on
a low battery charge. To continue use of the device charge the battery. If the
battery is completely discharged the device can not be switched on even when
the loading process is ongoing. Before the device can be turned on again, the
battery has to be charged for at least a few minutes. In case of any problems