Hammer A3-26, Руководство пользователя

Страница: 33 / 72

33
" !
10 5
0 10 5
0
10 5
0 10 5
0
0
10
5
1mm
Planer-Thicknesser
A3-26 / A3-31 / A3-41
• Planer table above circle of cut:
extremely open joint
• Planer table height at the circle of cut:
straight joint
• Planer table below circle of cut:
extremely splayed joint
8.3 Adjusting the joint
Fig. 8-2: Adjusting the joint
The receiver-side of the planer table is set so that with a
workpiece length of 2 m, an open joint of approximate-
ly 0.2 to 0.5 mm is produced (standard setting). The
position of the outfeed side of the planer table must be
adjusted with regards to the flight of the knife to achie-
ve particular requirements (extremely splayed, open or
straight joints):
The joint adjustment is carried out on the receiver-side of
the planer table:
Required tools:
Spanner 17 mm / 13 mm
1. Switch the machine off and ensure that it cannot be
switched on again.
2. Loosen the clamping screw.
(Spanner 13 mm)
3. Eccentric: turn until the desired height of the planer
table is reached
(Spanner 17 mm)
4. Tighten the clamping screw.
(Spanner 13 mm)
5. Check the adjustment with a gauge
!
Clamping screw
"
Eccentric
Checking the joint adjustment:
1. Prepare the gauge as shown in the illustration opposi-
te.
2. Set the gauge on the receiver-side of the planer table
edge to “0”.
3. Turn the cutterblock manually.
4. The planing knives should move the gauge
2 to 3 mm. (usual setting)
Fig. 8-3: Checking the joint adjustment
Attention! Risk of injury!
The planer knives are razor sharp. Handle the planer knives with the utmost care.
especially when turning the cutterblock by hand.
Making adjustments and preparations