(Wireless) ADSL VPN Firewall Router with 3DES Accelerator
Chapter 4: Configuration
42
Connection:
Always on:
If you want the router to establish a PPPoA session when starting up and to
automatically re-establish the PPPoA session when disconnected by the ISP.
Connect to Demand:
If you want to establish a PPPoA session only when there is a
packet requesting access to the Internet (i.e. when a program on your computer attempts to
access the Internet).
Idle Timeout:
Auto-disconnect the broadband firewall gateway when there is no activity on
the line for a predetermined period of time.
Detail:
You can define the destination port and packet type (TCP/UDP) without checking
by timer. It allows you to set which outgoing traffic will not trigger and reset the idle timer.
RIP:
RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.
MTU:
Maximum Transmission Unit. The size of the largest datagram (excluding media-
specific headers) that IP will attempt to send through the interface.
Advanced Options (PPPoA)
LLC Header:
Selects encapsulation mode, true for using LLC or false for using VC-Mux.
Create Route:
This setting specifies whether a route is added to the system after IPCP
(Internet Protocol Control Protocol) negotiation is completed. If set to
enabled
, a route will be
created which directs packets to the remote end of the PPP link.
Specific Route:
Specifies whether the route created when a PPP link comes up is a specific
or default route. If set to
enabled
, the route created will only apply to packets for the subnet
at the remote end of the PPP link. The address of this subnet is obtained during IPCP
negotiation.
Subnet Mask:
sets the subnet mask used for the local IP interface connected to the PPP
transport. If the value
0.0.0.0
is supplied, the netmask will be calculated from the class of the
IP address obtained during IPCP negotiation.
Route Mask:
Sets the subnet mask used by the route that is created when a PPP link
comes up. If it is set to
0.0.0.0
, the subnet mask is determined by the IP address of the
remote end of the link. The class of the IP address is obtained during IPCP (Internet
Protocol Control Protocol) negotiation.
MRU :
Maximum Receive Unit. This is negotiated during the LCP protocol stage.
Discover Primary / Secondary DNS:
This setting enables/disables whether the
primary/secondary DNS server address is requested from a remote PPP peer using IPCP.
The default setting for this command is
enabled
.
Give DNSto Relay:
Controls whether the PPP Internet Protocol Control Protocol (IPCP) can
request the DNS server IP address for a remote PPP peer. Once IPCP has discovered the
DNS server IP address, it automatically gives the address to the local DNS relay so that a
connection can be established.
Содержание HRDSL742
Страница 1: ...Version Release 1 54c HRDSL742 HRDSL742W Wireless ADSL VPN Firewall Router User s Manual...
Страница 2: ......
Страница 6: ......
Страница 62: ...Wireless ADSL VPN Firewall Router with 3DES Accelerator Chapter 4 Configuration 56 Packet Filter...