Hamilton HTK, Руководство по установке

Страница: 5 / 36

Document #101-0204 5 10/21/2011
II. Installation
NOTE: It is very important to read and understand all of these in-
structions before attempting installation.
Hamilton will not be
responsible for injury due to improper installation.
The installation process contains two distinct operations, Mechanical Installation , and Electrical
Installation
MECHANICAL INSTALLATION

Unpacking
There are a number of points to keep in mind while unpacking your HTK. These items will make the
installation and continued operation of your machine run smoother. These tips are listed below.
Be sure to save your keys
The keys and lock inserts are placed inside a cushioned envelope bag, then placed inside the machine
located next to the power supply. When removing the shrink-wrap, be sure to locate the “T” handle
crank and set it aside so it does not get thrown away. MAKE A PERMANENT RECORD OF THE
NUMBERS ON YOUR KEYS IN CASE A KEY IS LOST AND MUST BE REORDERED.
Remove the packing strap from the hoppers
The hoppers comes shipped with a packing strap secured around it to minimize the vibrations caused
by shipping. If this strap is not removed, the hopper will not tip out for easy fi lling. The strap may be
cut off with a pair of wire cutters or sturdy scissors. Cardboard is placed around the edges of the hop-
per to protect it during shipping. After removing the strap, be sure to remove the cardboard as well.
In addition to the removal of the card board and strapping,
one of the hoppers will be holding the
paper for the receipt printer.
Remove all packing debris from the hopper
During unpacking, ensure that debris does not fall into the hopper bowl. If this material is not removed,
the hopper could jam. With the power completely disconnected, remove all loose material inside the
hopper bowl.
Remove HTK from shipping pallet
The HTK is securely mounted to the pallet with 4 mounting bolts and nuts. To remove the HTK from
the pallet, open the main door and locate the cushioned envelope to retrieve the key for the vault. Once
you have the vault door open loosen and remove the two nuts from the bolts. Repeat this process on the
two bolts on the side of the power supply. Once this process is complete, you will be able to remove
the HTK from the pallet.
Removal of additional packing materials
Inside the HTK are additional components that have packing material holding the component in place
for secure shipping. The following will need to be removed for proper operation. The fi rst is the strap-
ping around the Validator. Another is the removal of the tape around the coin mechanism. In addition
the tape and paper on the front of the bill dispenser, this also incudes the tape that holds the bill rejection
tray. Finally the removal of the tape from the coin box, which need to be placed underneath the coin
mechanism inside the cabinet.