HTX30 Product Manual
Commissioning
5-23
Jet setup
Ensure that the waterjet steering nozzles and position sensors have been correctly set up and centred as
described in the waterjet product manual.
If not already running, start the blue ARROW Support Tool.
Double click
on
Setup the Modules
or click the
Jump to..
and select
Setup the Modules
, then click
OK.
Select
Set up the following modules
, and select the
JIM
.
Make sure that hydraulic power is available.
Select
Powered
for the calibration type.
Click
Next
to start calibration.
Make sure the jet units are free of obstructions.
Click
OK
to continue.
Most of the jet interface module settings will be
automatically configured.
Click the abort button at any time to cancel
configuration.
A progress bar indicates setup progress.
The configuration correctly sets values for the
steering deadband and limits, and the reverse duct
deadband and limits.
Содержание HTX30
