Hamilton Jet HJ212, Инструкция по установке и обслуживанию

Страница: 53 / 198

Installation and Service Manual
Commissioning
6 - Commissioning
In This Section
Pre-Launch Checks ................................................................................................................. 6-1
Post Launch Checks ............................................................................................................... 6-2
Engine Running Checks (Vessel Moored) .............................................................................. 6-2
Vessel Speed and Handling Trials .......................................................................................... 6-2
After Initial Trials (After Engine Shutdown) .......................................................................... 6-3
This information is intended for use by CWF Hamilton representatives. Refer to the controls system manual
for details of commissioning checks specific to the controls system.
Make sure that the vessel is securely moored during commissioning as the jet unit can
produce large thrust forces.
Make sure that all bearing housings are filled with the correct amount and grade of grease.
Refer to section: Recommendations for Lubricants and Oils on page 10-34.
Pre-Launch Checks
All cylinder shafts are protected with spiral wrap during shipping.
Make sure the wrap is removed before first operation.
Carefully inspect all hydraulic cylinder shafts and pushrods for scratches, paint, weld splatter,
dirt or any other contamination.
These shafts should be perfectly clean before the hydraulics are used to prevent damage to
the seals.
Make sure all inspection covers are securely fitted.
For steel hulls, make sure the insulation resistance between the jet unit and the vessel hull is greater than
1000 Ohms.
6-1