8
1.
Unplug blender from electrical outlet.
2.
Wipe blender base, control panel,
and cord with a damp cloth or
sponge. To remove stubborn spots,
use a mild, non-abrasive cleanser.
3.
To clean jar, unscrew cutting
assembly from jar.
4.
Carefully remove gasket from
cutting assembly.
5.
Remove dispenser from cutting
assembly.
• Rotate dispenser assembly 90º
counter-
clockwise to
unlock from
cutting
assembly
• Pull to remove dispenser assembly
from cutting
assembly.
6.
Carefully wash cutting assembly,
dispenser assembly parts, gasket,
jar, and lid in hot, soapy water. Rinse
and dry thoroughly. Do not soak.
Do not wash cutting assembly
or gasket in a dishwasher.
NOTE:
All parts except the cutting
assembly and gasket may be
washed in the dishwasher (on the
top rack only). Some part distortion
may occur if your household dish-
washer temperature is higher than
normal or if the parts are placed too
close to the heating element.
How to Clean
7. Reassemble
cutting unit assembly
onto jar, and replace jar onto blender
base. Ensure dispenser or spout cap
is fully pushed on spout and rotated
clockwise to lock into position
(reverse steps in number 5 above).
8.
Store blender with lid ajar to
prevent container odor.
OPTIONAL CLEANING
1.
To unsnap actuator from hinge on dis-
penser, push
dispenser with
thumb while
pulling dis-
penser lever
with fingers.
This releases
dispenser from
hinge.
2.
Lift and rotate actuator around
hinge.
Unscrew dis-
penser cap.
3.
Lift dispenser cap and actuator
straight up to
remove the
interior plug
attached to
the cap from
the dispenser
body.
w
WARNING
Electrical Shock Hazard
• Disconnect power before cleaning.
• Do not immerse cord, plug or base
in any liquid.
Failure to follow these instructions
can result in death or electrical shock.
840153700 ENv02.qxd 6/22/06 5:16 PM Page 8
