CONTROL PANEL
First select and push a
LOW or HIGH power but-
ton then push desired
speed button.
The blender will run until you push the OFF button.
The OFF button is also the Ice Breaker
™
/Pulse Button.
When using Pulse or IceBreaker, the blender will only
run as long as the button is pushed. As buttons are
pushed left to right, the speed at which the blades
spin will increase.
BEFORE FIRST USE
After unpacking the blender, wash everything except
the blender base in hot, soapy water. Dry thoroughly.
Wipe the blender base with a damp cloth or sponge.
DO NOT IMMERSE THE BASE IN WATER. Care should be
taken when handling the cutting blades as they are
very sharp.
HOW TO ASSEMBLE AND USE
6
IMPORTANT: Your blender jar and cutting blades are sub-
ject to wear during normal use. Always inspect jar for
nicks, chips, or cracks. Always inspect cutting blades for
broken, cracked, or loose blades. If jar or cutting blades
are damaged, do not use. Call our toll-free customer
service number to obtain replacement parts.
■
Make sure blender is unplugged. Place blender base
on clean, dry surface to keep foreign particles from
being pulled up into motor during operation.
■
Place cutting blades in Sure Rest
™
jar base. Set jar on
top of cutting blades and tighten on jar base.
■
Make sure the Sure Rest
™
jar base is firmly screwed
onto the jar. If not, it may loosen later when motor is
turned on.
840141300 Blender 12/20/05 11:23 AM Page 6
