HAMACO ML-150-45V-D12, Руководство пользователя

Страница: 10 / 11

Maintenance and Inspection Safety
Before entering lift for maintenance or inspection, please follow these steps to prevent serious or fatal injuries.
Please note that stoppers, vises, and other tools necessary for maintenance are
not included with this lift.
1. Remove any load from the table
2. Raise the table at least half way.
If the table has bellows, either remove the four screws on
the table side and take down the bellows or roll up from the
chassis side.
3. Engage two stoppers (block) ① against the left and right
arm rollers, then fasten securely with a vise ② .
4. Stand two stoppers (steel)
③
perpendicular to the
end of the arm support shaft side, then fasten
securely with a vise
④
.
5. Turn the power off.
DANGER
DO NOT HOIST TABLE WITH LIFT CRANE OR OTHER EQUIPMENT.
FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN SERIOUS INJURY
AND/OR EQUIPMENT DAMAGE.
DO NOT TOUCH THE CONTROL BOX BOARD FOR AT LEAST FIVE SECONDS AFTER POWERING
DOWN TO ALLOW ELECTRICITY TO FULLY DISCHARGE.
FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN ELECTRICAL SHOCK.
BEFORE REMOVING MOTOR, TAKE PROPER PRECAUTIONS TO PREVENT
THE LIFT FROM DESCENDING.
Unlike a hydraulic lift, the table will drop immediately without support.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SERIOUS INJURY AND/OR DEATH
Inspection Checklist
Please perform daily inspections in addition to more thorough periodic inspections
If daily inspection were to find an abnormality, immediately stop operation, find the cause and
resolve the issue.
Continued use without repair may render the lift inoperable.
Daily Inspections
• Is there anything abnormal in lift rise or descent operation?
• Are there any obstructions in the surroundings?
• Is anything abnormal about the unit’s appearance?
• Are there any abnormal sounds or heat generation?
Periodic Inspections (monthly, quarterly and annually)
• Are there any damaged or loose bolts, nuts or other parts at any connecting sections?
• Is there abnormal wear in any moving sections?
• Are there any cracks or damages at welded sections?
• Are there any cracks or damages in the electrical wiring?
Lubrication
• Check and apply roller chain lubrication at periodic inspection.
• Check the dry cylinder gear and ball screw sections annually.
With sealed-in long-life lubrication, they are designed to work for extended periods without additional
lubrication. However, once per year, overhaul them or replace the dry cylinders with new ones.
IF MAINTENANCE PROBLEMS PERSIST CALL THE LOCAL DISTRIBUTOR OR HAMACO INDUSTRIES
CORPORATION WITH THE SERIAL NUMBER OF THE SPECIFIC EQUIPMENT TO ORDER THE
APPROPRIATE PARTS.
MAINTENANCE
②
④
③
①