7
Note
•
Initial setup takes approximately 3 minutes.
•
During the connection attempt, the radio symbol and the LED
indicator (1) on the measuring station will flash.
•
Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors and
inaccuracies.
•
The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
•
The measured value is automatically updated by the base device
about every 57 seconds.
6.2. Selecting the channel/Other measuring stations
Note
•
You can connect up to three different base stations to the measuring
station. Ensure that the base station and measuring station are set to the
same channel. Suitable base stations can be found at www.hama.com
•
The transmission channel on the supplied measuring station can be
changed/set (
CH1, CH2, CH3
).
•
The measuring station is suitable for the following base stations:
76045, 113964, 123126, 123127,123128, 123129, 136256, 136257,
136258, 136259, 186306, 186307, 186308; 186353, 186354,
186417, 186418
6.3. Low battery charge
Note – Replacing the batteries
•
Note that the stations have to be resynchronised each time after
you change the batteries in the measuring or base station.
•
To do this, remove the batteries from the other station and then
reinsert them, or change them as required.
