Hama Retro, Руководство по эксплуатации

Страница: 3 / 36

3
Warning - Batteries
• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using the device in extreme temperatures and extremely low
atmospheric pressure (for example, at high altitudes).
4. Getting Started
Remove the battery that was already inserted into the clock, remove the protective film if necessary as
well as the contact interrupter and the re-insert the battery with the correct polarity.
5. Operation
5.1 Setting the time
• Use the setting wheel on the rear to set the time (hours/minutes).
• To set the seconds, remove the battery to stop the seconds. Put the battery back in to start the
seconds hand again at the right second.
5.2 Setting the alarm
• Move the setting wheel on the back of the alarm clock in the direction of the arrow to set the
appropriate alarm time. The hand for the alarm time moves in an anticlockwise direction.
• To activate/deactivate the alarm, move the slide switch to the ON or OFF position.
6. Care and Maintenance
Only clean this product with a slightly moist, lint-free cloth, and do not use aggressive cleaning agents.
Make sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
8. Technical Data
“Retro” alarm clock
a
Power supply 1.5 V
1 x AA battery