6
7
5.4. Alarm settings and display
• Press the
mode
button (4) repeatedly until
AL1
is displayed.
• Hold the
mode
button (4) for approx. 3 seconds. The hours display begins to flash.
• Press the
p
button (2) or the
q
button (3) to select the hour for the alarm time and confirm your selection
by pressing the
mode
button (4). The minutes display begins to flash.
• Repeat the process to set the minutes for the alarm time. Once you have confirmed your minutes selection
with the
mode
button (4), alarm 1 is activated and
1
appears.
• You can also set a second alarm time.
• Press the
mode
button (4) repeatedly until
AL2
is displayed and repeat the settings for
AL1
.
• Press the
button (6) to activate/deactivate alarm time 1, alarm time 2 or both at once. The alarm
symbols
1
and/or
2
will appear/not appear.
• If the alarm is triggered, the corresponding alarm symbol will begin to flash and an alarm will sound.
• Press the
button (6) to stop the alarm. Otherwise, it will stop automatically after 4 minutes.
• If you press the
SnOOZE / LIGHt
button (1) during the alarm, the alarm is interrupted for 4 minutes and
then goes off again. The corresponding alarm symbol and the snooze symbol
Z
Z
will flash.
5.5. Settings and display for a second time zone
• Press and hold the
p
button (2) for approx. 3 seconds to display the second time zone as the main time.
The
F
symbol appears next to the time.
• Press the
mode
button (4) repeatedly until the temperature is displayed.
• Press and hold the
mode
button (4) for approx. 3 seconds to set a second time in another time zone. The
hours display begins to flash.
• Press the
p
button (2) or the
q
button (3) to make the setting and confirm your selection by pressing the
mode
button (4).
• To switch to the current local time, press and hold the
p
button (2) again for approx. 3 seconds.
The
F
symbol is no longer displayed.
5.6. Dual time settings and display
• Press the
mode
button (4) repeatedly until
DUAL tIME
is displayed.
• Press and hold the
mode
button (4) for approximately 3 seconds. The hours display begins to flash.
• Press the
p
button (2) or the
q
button (3) to make the setting and confirm your selection by pressing the
mode
button (4). The minutes display begins to flash.
• Repeat the process to set the minutes.
5.7. temperature display
• Press the
mode
button (4) until the temperature is displayed.
• Press the
°C/°F
button (5) to choose between °C and °F for the temperature display.
5.8. Backlight
If you press the
SnOOZE / LIGHt
button (1), the display will light up for approx. 5 seconds.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Make
sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
Содержание RC 130
Страница 13: ...24 25 3 4 8 8 5 p 2 q 3 5 1 DCF DCF 3 5 DCF...
