13
4. The ‘ ’ icon in main unit will stop fl ashing
after two minutes to prompt user that it
already exits sensor searching mode. In this
case, the user must press and hold
[CH]
button
for 2 seconds to re-enter sensor searching
mode and repeat above steps if he wants to
register a new remote sensor.
REMOTE CHANNEL AUTO-SCROLLING
This device is equipped with an Auto-scroll
function. While the Auto-scroll function is set, the
main unit will automatically cycle to display the
indoor temperature and the temperature of each
remote sensor for 4 seconds.
1. To manually retrieve the specifi c sensor
temperature reading, press
[CH]
key until
desired channel number is displayed.
2. To enable Auto-scroll function, use [CH] button
to select channel 1,2, ... until auto scroll
icon appears beside the channel indicator.
DCF-77 RADIO CONTROLLED CLOCK
The radio-controlled time is calculated by the
Cesium Atomic clock of Braunschweig (offi cial
clock of Germany). Then the time is coded and
transmitted from Mainfl ingen - near Frankfurt -
via a signal on DCF-77 (77.5 kHz). The transmitting
range of the signal is 1500 km, which means that
most of Western and Central Europe is covered
by this signal. Within this range the received time
is completely accurate. Once sensor signal(s) are
received, the wave icon will fl ash to indicate that
the receiving unit starts to receive the DCF radio
controlled time signal. Radio Controlled wave
icon indicates 4 levels of signal status:
very
weak
medium
strong
weak
As soon as the time signal is received, the wave
icon will stay on the LCD, and time and calendar
will automatically be updated.
Note:
During the 10-minute time signal reception,
all manual key input will be ignored. In addition,
the continuous mood light or Alert light will be
turn off temporary until reception is over. You can
also press and hold [ ] key for 2 seconds to
manually activate the reception in normal mode.
SET THE CLOCK, CALENDAR & TEMPERATURE
UNIT
1. Press & hold
[MODE]
button for 2 seconds
to enter clock setting mode. Flashing
24Hr
will
appear.
2. Press [ ] or [ ] button to switch between
24Hr
and
12Hr
format, and then press [MODE]
button to confi rm.
3. The hour digits will fl ash. Use the [ ] button
to increase by one hour or [ ] button to
decease by one hour to your desired hours.
Holding down either button will change the
increment unit rapidly. Press [MODE] button to
confi
rm.
4. The minute digits will fl ash. Use the [ ] or
[ ] button to set your desired minutes.
Holding down either button will change the
increment unit rapidly. Press
[MODE]
button to
confi
rm.
Note:
Every change of minute digit will
automatically reset the seconds to zero.
5. The year digits will fl ash. Use the [ ] or [ ]
button to set your desired years. Holding down
either button will change the increment unit
rapidly.
Press
[MODE]
button to confi rm.
Note:
Year range is from 2000 to 2099.
6. The DATE-MONTH/MONTH-DATE digits will
fl ash. Use the [ ] or [ ] button to choose
DATE-MONTH or MONTH-DATE, press
[MODE]
button to confi rm. Then use the [ ] or [ ]
button to set your desired months and days.
00092658bda.indd Abs1:13
00092658bda.indd Abs1:13
25.11.09 09:14
25.11.09 09:14
