1. Make sure that the mouse is NOT in power saving mode. If the mouse is in
power saving mode, you must click one of the buttons to activate it.
2. Press the scroll wheel (Fig.4) and hold it down.
3. Then press the connect button (Fig.5).
4. The mouse is now switched off, i.e. it is not ready for operation.
Switching the mouse on
Follow the same procedure to switch on the mouse (point 2 and 3).
Power saving mode
If the mouse is not used for 10 minutes, it switches to power saving mode. The
optical sensor is switched off to minimise the power consumption. In this mode,
no actions can be performed using the mouse. Press any button to activate the
mouse.
Installing the software
•
The software supports Windows® 98SE/2000/ME/XP
•
Uninstall any mouse software already installed.
a) Place the enclosed CD in your CD-ROM or DVD-ROM drive. Wait a moment,
installation is started automatically. If it does not start automatically, click
Start => Run, enter “X:\Setup” (where "X” is the drive letter of your CD-ROM
drive) and press Enter to confirm.
b) Select the required language and click Next.
c) Restart your PC to complete installation.
d) After installation is complete, the mouse symbol appears in the task bar.
Note:
During installation under Windows® XP, a message may appear regarding an
unsigned driver. This does not affect mouse or software operation. Simply ignore
and continue with the installation process.
11
00052498bda 23.06.2006 12:07 Uhr Seite 11