047454
205291
G
Operating instruction
182223
1. Safety instructions
•
Protect the product from moisture.
•
Do not leave the SAT
fi
nder permanently installed between the SAT dish and the
receiver.
•
Take proper safety precautions when working on the roof (risk of falling). If in doubt,
contact a quali
fi
ed technician and do not attempt to mount the product yourself!
2. Adjusting the SAT system for the best possible reception using the SAT
fi
nder
•
Disconnect the SAT receiver from the power supply and connect the SAT
fi
nder as
shown with the short F cable between the LNB and receiver.
•
Reconnect the receiver to the power supply, select a channel.
•
Adjust the sensitivity controller (1) until the level jumps.
•
Using a protractor and compass, roughly adjust the SAT antenna (SAT dish) accord-
ing to the desired satellites. Search for the proper satellite by turning and panning
the SAT antenna.
•
The stronger the incoming SAT signal, the higher the measurement tone that
sounds; the level (needle) on the signal strength display (2) also rises from weak
“1”
to medium to strong
“10”.
•
If the level reaches the maximum of
“10”,
turn down the sensitivity controller (1)
until the level shown is reduced.
•
Now
fi
nely tune the antenna to get as close to the maximum value of
“10”
as
possible.
•
Tighten the antenna fasteners.
•
WARNING: The set value can change again when the screws are tightened.
•
On your receiver, check if the desired satellite can now be received.
•
You can now remove the SAT
fi
nder and reconnect the LNB and the receiver.
Hama GmbH & Co KG
86652 Monheim /
Germany
Service &
Support
+49 9091 502-0
DG
All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and
subject to technical changes. Our general terms of delivery and payment are applied.
RO
00
04
74
54
_0
20
52
91
_0
18
22
23
/1
0.
20
Содержание 047454
Страница 2: ......