7
Warning - Batteries
•
When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries
accordingly. Failure to do so could result in the
batteries leaking or exploding.
•
Only use batteries (or rechargeable batteries) that
match the specified type.
•
Before you insert the batteries, clean the battery
contacts and the polarity contacts.
•
Do not allow children to change batteries without
supervision.
•
Do not mix old and new batteries, or batteries of
different types or from different manufacturers.
•
Remove the batteries from products that are not
being used for an extended period (unless these are
being kept ready for an emergency).
•
Do not short-circuit batteries.
•
Do not charge batteries.
•
Do not burn batteries.
•
Keep batteries out of the reach of children.
•
Never open, damage or swallow batteries or allow
them to enter the environment. They can contain
toxic, environmentally harmful heavy metals.
•
Remove spent batteries from the product and
dispose of them without delay.
•
Avoid storing, charging and using in extreme
temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
4. First steps - Inserting the batteries
Note
•
Alkaline batteries are recommended. Use two
batteries of the type "AAA" (LR 03/Micro).
•
Remove the battery cover on the back of the
universal remote control (A).
•
Insert the batteries, observing the "+/-" marks for
polarity (B).
•
Close the battery compartment (C).
Note: Code memory
•
When replacing the batteries, all the codes you
have programmed remain stored for up to 10
minutes. Make sure that you do not press any
buttons until the new batteries are inserted in the
remote control. If you press a button and there are
no batteries in the remote control, all codes will
be deleted.
Note: Energy saving function
•
The remote control switches itself off automatically
if a button is pressed for longer than 15 seconds.
This prolongs the life of the batteries if the remote
control is stuck in a place where the buttons are
pressed permanently, e.g. between sofa cushions.
5. Setup
Note
•
For proper infra-red transmission, always hold the
remote control in the approximate direction of the
device to be operated.
•
Press the "MODE" button to select the secondary
device group: AUX, AMP,DVB-T, CBL (8 in 1 model
only).
•
Press the "SHIFT" key to control the blue function
keys. The shift function is deactivated by pressing
the "SHIFT" key again or automatically after 30
seconds if no key is pressed.
•
If no entry is made within 30 seconds, SETUP mode
is automatically terminated. The LED flashes six
times and then goes out.
Содержание 00012306
Страница 2: ......
