Thingsee LEAKAGE RUGGED detects liquid underneath the device. The
sensor detects a solid water layer between the two detection pins at
the bottom of the device. The product is placed on the floor or place of
potential leakage risk pins down.
The sensor can be used for leakage detection on floors, flat surfaces
and pipes where flooding, leakage or even condensed water may take
place.
Sales package content
• Thingsee LEAKAGE RUGGED sensor
• Magnetic switch
• User guide
Using Thingsee LEAKAGE RUGGED sensor
Thingsee LEAKAGE RUGGED uses event based messaging where
measurement is done every 30 seconds. In case there is a change to the
previous measurement, the measured value will be reported
immediately. In case the measurement value remains the same, it’s
reported once in every 1 hour.
Please note that the measurement values highly depend on the liquid
in question: for example, clean tab water and salty sea water give
different values. We recommend the location to be checked for
leakages every time a high decrease of the measurements value is
observed.
