LIMITED WARRANTY
Lockin Pty Ltd trading as Haltech warrants the Haltech
TM
Programmable Fuel Injection System to be
free from defects in material or workmanship for a period of
12 months
from the date of purchase.
Proof of purchase, in the form of a bill of sale or receipted invoice, which indicates that the product is
within the warranty period, must be presented to obtain warranty service. Lockin Pty Ltd trading as
Haltech suggests that the purchaser retain the dealer’s dated bill of sale as evidence of the date of
retail purchase.
If the Haltech
TM
Programmable Fuel Injection System is found to be defective as mentioned above, it
will be replaced or repaired if returned prepaid along with proof of purchase. This shall constitute the
sole liability of Lockin Pty Ltd trading as Haltech.
To the extent permitted by law, the foregoing is exclusive and in lieu of all other warranties or
representations, either expressed or implied, including any implied warranty of merchantability or
fitness. In no event shall Lockin Pty Ltd trading as Haltech, be liable for special or consequential
damages.
DISCLAIMER
Haltech will not be held responsible for any damage caused by the incorrect installation or tuning of this
product. It is the installers responsibility to ensure the wiring connections and pinouts match that of the
vehicle the unit is being installed into.
Haltech has taken all care to make sure the connections match the specified vehicles listed, but variations
in wiring and connections on vehicles can occur and therefore this should be checked BEFORE the unit
is installed.
Haltech highly recommends installation and tuning of this product is to be carried out by a professional,
with an understanding on installing and tuning engine management systems.
Misuse of this product can destroy your engine.
WARNING – HALTECH OFF-ROAD USAGE POLICY
It is unlawful to tamper with your vehicle's emissions equipment.
This ECU is designed and sold for Sanctioned Offroad/Competition Non-Emissions Controlled Vehicles
only. Using this product for street / road use on public highways is prohibited by law. It is the responsibility
of the installer and/or user of this product to ensure compliance with all applicable local and federal laws
and regulations. Please check with your local vehicle authority before using this product.
GENERAL INSTALLATION WARNING
Avoid open sparks, flames or operation of electrical devices near flammable substances.
Always disconnect the battery cables when doing electrical work on your vehicle.
Do not charge the battery with a 24 Volt truck charger or reverse the polarity of the battery or any charging
unit. Do not charge the battery with the engine running as this could expose the ECU to an unregulated
power supply that could destroy the ECU and other electrical equipment.
All fuel system components and wiring should be mounted away from heat sources, shielded if necessary
and well ventilated. Disconnect the Haltech ECU from the electrical system whenever doing any arc
welding on the vehicle by unplugging the wiring harness connector from the ECU.
After completing the installation, make sure that there are no fuel leaks, and no wiring left un-insulated in
case a spark or short-circuit occurs and causes a fire. Also make sure that you follow all proper workshop
safety procedures. If you're working underneath a jacked-up car, always use safety stands!
Notes
