4
2.4
OVERALL DIMENSIONS AND MINIMUM CLEARANCES
The EDEN 'x-type' range can be installed to a number of different
concentric flue systems. The different flue applications as shown in
Figure 2 are available as kits usually comprising the connecting
2.5
CONCENTRIC AIR / FLUE DUCT SPECIFICATIONS
8
FLUE OPTIONS
2
Vertical flue kit - Part no. 956081
with flat roof flashing plate
Vertical flue kit - Part no. 956081
Flue system application
Vertical flue kit - Part no. 956081
Split pipe vertical flue outlet kit
- Part no. 956080
with flat roof flashing plate
Raised external flue outlet kit
- Part no. 956084
Chimney flue liner kit
- Part no. 956082
External vertical flue kit
- Part no. 956085
Standard horizontal flue kit
- Part no. 956083
The following flue systems are available for the EDEN 'x-type' range
parts to the appliance and end terminal. Flue extension ducts and
extension elbows are available as accessories.
1
A
B
C
D
E
F
G
H
I
J
K
L
M
EDEN VBX 18
320
280
150
97
100
694
200
540
400
200
5
5
200
EDEN VBX 30
360
320
150
97
100
694
200
540
400
200
5
5
200
M
A
J
L
K
B
C
E
D
G
H
I
F
33
Refer to Figures 22 & 27
a)
Ensure supply voltage is isolated.
b)
Unclip the user interface from its housing (see figure 22).
c)
Lower the controls front.
d)
Unplug the electrical leads from the PCB. Refer to section 7.
e)
Unplug the BCC (boiler chip card) if fitted.
f)
Remove the PCB plastic cover.
g)
Unclip the PCB and withdraw.
h)
Fit the new PCB and plug in the BCC if previously used.
i)
Re-assemble in reverse order.
j)
If the boiler requires resetting turn the CH Temperature Control
knob anti-clockwise to 'STANDBY' position and then back to 'ON'
within two seconds. Refer to section 5.4.
9.13
CONTROL PCB
Refer to Figure 48
a)
Ensure supply voltage is isolated.
b)
Disconnect the electrical lead from the flue sensor.
c)
Unscrew the flue sensor and remove from the flue hood.
d)
Fit the replacement flue sensor and reconnect the electrical
lead (blue plug).
9.11
FLUE SENSOR
48
FLUE SENSOR
Refer to Figure 30
a)
Ensure supply voltage is isolated.
b)
Open the drain sump cap, while holding a receptacle
beneath to capture any condensate.
c)
Disconnect the condensate drainpipe from the appliance.
d)
Undo the two locknuts holding the system in place.
e)
Unclip the hose from the support bracket.
f)
Detach the condensate drainpipe sump adaptor, by gently
pulling down.
g)
Remove the condensate drain system, clean or replace as
necessary.
h)
Re-assemble in reverse order; ensure that all joints and seals
are correctly re-fitted.
9.12
CONDENSATE DRAIN SYSTEM
