Step 2:
Charge your Personal Electronic Device
Using the supplied HALO Charge It Charge Me™ cable, plug one USB connector into the HALO
Power Charger, insert the provided appropriate tip into your device (You may also use your own
USB cable that was supplied with your personal electronic device.),press and hold the Power
Button for about 2 seconds to begin charging. The Red LED will start flashing when the HALO
Power Charger is out of power before shutting down.
NOTE: Using the supplied HALO Charge It Charge Me™ cable, you can charge both the HALO
Power Charger and your electronic device at the same time. To do this you must first plug either
USB connector into a computer (or another 5V input USB charging source), and then connect
the Halo charger and your electronic device.
To Turn ON/OFF the HALO Pocket Power
The unit may be turned ON/OFF by depressing the power button for 3 seconds.
Power Indicator/Status
To check the remaining power level of the Power Charger 2800, press and release the Power
Button twice and the LED will flash the remaining power level. Please refer to LED Power
Indicator above for breakdown of LED power level color breakdown.
Storing the HALO Pocket Power
Please keep the unit out of extreme temperature conditions and do not get wet.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
15.21
You are cautioned that changes or modifications not expressly approved by the party
responsible
for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, theuser is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver
* Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
* Consult the dealer or an experienced radio/TV technician for help.
Limited Warranty
Halo2Cloud, LLC warrants its products to be free from defects in material and workmanship under normal use
conditions, as follows:
• During the first ninety (90) days from date of purchase, Halo2Cloud, LLC will repair or replace the defective product.
