4
4
3. TRIM ADJUSTMENT
3.1. SEAT HEIGHT AND REAR SET-UP
Acting on the AwP is possible to change the height and seat rear set-up.
•
The
AwP
support is connected to the main frame with four screws: one in front “A”
acting as fulcrum and three in the back “B” for angle adjustment.
•
Remove the screws “B” in the back and loose the one in front.
•
Raise or lower the rear seat to the desired position chosen from the available
positions.
•
Replace and tighten the screws “B” and tight them properly as well the “A”
On the AwP support, it is possible to insert the bush axle holder in five different positions in
order to obtain little set-up adjustment without touching the AwP assembly to the frame.
•
Remove the inside bolt that fixes the bush to the AwP supports.
•
Insert the bush in the new position.
•
Fix again tightly the bolt paying particular attention to the washers.
Notes: With extreme balancing set-up, the wheelchair become easier to push but it requires a
good user stability self control.
Once the seat tilt has been changed, the front fork plate holders need to be adjusted to
be perpendicular to the ground.
Clothes guards may need to be repositioned according with the new wheels position.
Brakes also may need to be readjusted according with the new set-up.
