Dec 19
2 - 2
The Preventer fully rigged
4.
Method
.
•
Route the preventer line from the aft quarter on the windward side
•
Use windward midships spinnaker block
•
Use forward cleat threading the preventer out to in
•
Route the free end aft on the leeward side to just aft of the shrouds
•
Tie to rail do not leave loose.
•
Untie preventer lanyard under boom
•
Tie preventer to loop in lanyard using a round turn and 2 half hitches
•
Do not use a bowline
– the knot will become too tight
•
Sheet out the main further than sail trim requires
•
Pull the preventer tight and secure to aft windward cleat using an OXO
•
Sheet in the main sail sheet to set the sail trim and tighten the preventer line
•
Do not leave slack in the preventer line
it must be fairly taught.
•
Release the OXO and let the preventer run free if you need to heave to or tack
Preventer – routed
over starboard rail
Preventer tied to
lanyard with
round turn & 2
half hitches
Preventer lanyard
Содержание 34.2
