Dd
Programmable 8-button IP Keypad Wall Plate
© Copyright 2018 Hall Research, Inc.
17
Command
Response
Description
VER
<SPACE>-----> vx.xx <-----<CR><LF>
(There is a leading space)
Show installed firmware version.
Note there is a single leading space character
in the response.
FADEFAULT
Set the device to factory defaults
ETH_FADEFAULT
Set IP settings to factory default
REBOOT
If a valid command is used, most likely
there will be no response unless there was
a command formatting error.
Reboot the device
HELP
Show the list of available commands
HELP N
where N=command
Show description of command specified
RELAY N N1
where N=1
N1= OPEN, CLOSE, TOGGLE
RELAY N N1<CR><LF>
Relay control
LEDBLUE N N1
where N=1~8
N1=0-100%
LEDBLUE N N1<CR><LF>
Individual button blue LED brightness control
LEDRED N N1
where N=1~8
N1=0-100%
LEDRED N N1<CR><LF>
Individual button red LED brightness control
LEDBLUES N
where N=0-100%
LEDBLUES N<CR><LF>
Set the brightness of all blue LEDs
LEDREDS N
where N=0-100%
LEDREDS N<CR><LF>
Set the brightness of all red LEDs
LEDSHOW N
where N=ON/OFF/TOGGLE
LEDSHOW N<CR><LF>
LED demo mode
BACKLIGHT N
where N=0-100%
BACKLIGHT N<CR><LF>
Set the max brightness of all LEDs
KEY_PRESS N RELEASE
KEY_PRESS N RELEASE<CR><LF>
Set the key press trigger type to “Release”.
KEY_PRESS N HOLD
KEY_PRESS N HOLD<CR><LF>
Set the key press trigger type to “Hold”.
MACRO RUN N
RUN MACRO[N] EVENT.<CR><LF>
x
x
where x = the macro commands
Run the specified macro (button).
The response also occurs if a button is
pressed.
MACRO STOP
MACRO STOP<CR><LF>
Stop all the running macros
MACRO STOP N
N=1~32
MACRO STOP N<CR><LF>
Stop the specified macro.
DEVICE ADD N N1 N2 N3
where
N=1~16 (Device slot)
N1=X.X.X.X (IP Address)
N2=0~65535 (Port Number)
N3={Name} (Up to 24
characters)
Add TCP/TELNET device in Slot N
The name may not contain any spaces.
DEVICE DELETE N
where
N=1~16 (Device Slot)
Delete the TCP/TELNET device in Slot N
DEVICE N N1
where
N=ENABLE, DISABLE
N1=1~16 (Device Slot)
Enable or Disable TCP/TELNET device in
Slot N
