Hall Research Technologies HHD264 Скачать руководство пользователя страница 2

Copyright 2017 Hall Research 

Pg 2 

 

 

 
If the Switch does not support DHCP: 

 

If the switch does not support DHCP, you have to configure each unit to a static IP 

one by one

 by 

using the PC GUI. 

 

As we know, all the devices on the network will have an IP. The HHD264-S and HHD264-R comes 
with a default IP address 192.168.1.11 and 192.168.1.12 with subnet mask "255.255.255.0" 
respectively. 

 

If you think the unit is not responding, just reset using factory reset button on the unit by 
holding it for 10 seconds. This will restore the IP to the default settings. 

 

To configure the HHD264 to a static IP, you have to know its current IP that can be found  in 

two

 

ways.  

 

One way of knowing this is by using an On Screen Display (OSD) by connecting the 
receiver (RX) to a display (480p minimum). 

 

The other way is by using the Windows GUI and configuring the PC’s IP to the HHD264’s 
default network (Recommended).  

Know the IP address Using OSD 

 

Connect the receiver (RX) to a display and know the IP address from the OSD displayed. 

 

To know the sender’s IP, connect it to the RX using a CAT5e/6 cable directly without 
using a switch. Know the sender’s IP address from the OSD displayed.  

 

 

To increase the time the OSD appears on screen, set the TX and RX to a different group.  

 

Configuring Static IP addresses using Windows GUI 

(Recommended)

 

 

Connect the receiver to the PC using a network switch. 

 

Setting the IP address of the PC to be in the same network subnet as HHD264 is a 
key factor to find the devices on the network. 

 
 

 
 

 

 

Change the IPv4 address of the PC to a Class-C static address ( 192.168.x.xxx) with 
subnet mask (255.255.255.0). 

Example: 

  
 

Note:   

 

HHD264

 must be connected one by one while setting the Static IP configuration 

as all the units have the same default IP, connecting more than one could result in 
IP conflict.  

 

All the devices in the network must have a unique IP address. Two senders cannot 
be in the same group. 

 

To be in the same channel, receivers must be in the same group as the sender.   

 

No two transmitters can be in a same group. 

Receivers should in the same group as transmitter.   

 

 

Отзывы: