User’s Manual
12
Command:
COn,m<cr>
stands for Connect Output n to input m
Response:
COn,m<cr>
Variations:
Command:
COn <cr>
stands for Connect Output n Query
Response:
COn,m<cr>
Command:
CO*,m<cr>
stands for Connect All Outputs to input m
Response:
CO1,m<cr>
CO2,m<cr>
CO3,m<cr> (for 4x4 matrices only)
CO4,m<cr> (for 4x4 matrices only)
4.2 Preset Save and Recall Functions
Command:
PRx<cr>
stands for Preset Recall. x = preset 1~ 8
Response:
CO1, m
1
<cr>
CO2, m
2
<cr>
CO3, m
3
<cr> (for 4x4 matrices only)
CO4, m
4
<cr> (for 4x4 matrices only)
Command:
PSx<cr>
stands for Preset Save. x = preset 1~ 8
Response:
None (the current tie pattern is saved in EEPROM)
4.3 Power Functions
Command:
PW1<cr>
stands for Power On
Response:
PW1<space><cr>
CO1, m
1
<cr>
CO2, m
2
<cr>
CO3, m
3
<cr> (Only for 4x4 matrices)
CO4, m
4
<cr> (Only for 4x4 matrices)
Important Note on Power ON Command
This command can take up to 10 seconds to complete. Upon powering up the unit will recall
the previous state of each output prior to powering off and restore each connection.
Command:
PW0<cr>
stands for Power Off
Response:
PW0<cr>
Variation:
Command:
PW
<cr>
stands for Power Query
Response:
PWx<cr><lf> x=0 (off), or 1 (on)
4.4 Special Commands
Command:
FB
<cr>
stands for Firmware Boot
Response:
Depends on power state when the command was issued. This command is
equivalent to unplugging the power supply and reconnecting it.
