Hali-Brite HBM 150/2, Руководство по установке и обслуживанию

Страница: 16 / 21

16
HBM 150/2 Installation and Maintenance Manual
5. Remove the setscrews in the motor gear, and remove the gear. ( NOTE:
There are two setscrews in each hole.)
6. Disconnect the motor black wire from control panel.
7. Disconnect the wires from the capacitor.
8. Remove the nuts from the four motor cap screws.
9. Remove the motor and gearbox.
10. If replacing only the motor, separate the old motor from the gearbox, and
replace with the new motor.
11. If replacing only the gearbox, separate the gearbox from the motor, and
replace with the new gearbox.
12. Install the new motor and gearbox back on to motor plate with the four
cap screws and nuts.
a. ( NOTE 1: Make sure the shaft of the gearbox is to the right.)
b. ( NOTE 2: Make sure the wires of the motor are facing out.)
13. Reinstall the gear on the shaft of the gearbox, and tighten the setscrews.
14. Reinstall the belt on the two gears, and tighten the belt by sliding the
motor to the left, and tighten the cap screws and nuts. ( NOTE: Adjust the
timing belt for no more than 1/8” deflection.)
15. Reconnect the wires to the motor capacitor. Red wire on the left side, and
the two white wires on the right side.
16. Reconnect the black wire to the neutral on control panel.
17. Reconnect the power to the beacon.