5. Once the axle stands are properly located, VERY SLOWLY turn the pole section of the handle
anti-clockwise until the vehicle begins to lower onto the stands. Lower the vehicle slowly so as
not to shock load the jack stands.
6. BEFORE GOING UNDER THE VEHICLE ensure that all axle stands and chocks are correctly
in place and there is no chance of the vehicle becoming unstable.
TO LOWER THE VEHICLE:
Once repairs are completed raise the vehicle slightly, remove the axle stands and VERY SLOWLY
turn the pole section of the handle anti-clockwise until the vehicle begins to lower.
CAUTION:
Ensure all body parts are kept clear of the jack and vehicle during the raising and
lowering operation.
MAINTENANCE, CARE AND LUBRICATION
1. This jack contains no user serviceable parts. Any modification will render the jack unsafe.
2. All moving joints require lubricating often. Lubricate all linkages, pivot points and castor wheels
using a grease gun.
3. Regularly check the plunger, main piston and linkages for signs of corrosion. Clean any light
surface corrosion with a suitable maintenance spray. If the corrosion is deeper than surface
do not attempt to use.
4. When not in use keep the jack stored on all 4 wheels with the arm and plunger all the way
down to prevent corrosion.
TO ADD OIL
IMPORTANT
When adding or replacing oil, ONLY use a quality hydraulic oil adhering to ISO VG 32
or similar. DO NOT use brake fluid, transmission fluid, alcohol, glycerine, detergent motor oil,
or dirty oil etc. as improper fluid will cause serious internal damage to jack making it unsafe to use.
1. Place the jack on level ground with the lifting arm and plunger fully lowered.
2. Remove the top cover plate and clean the surrounding area of the oil filler plug and remove
ensuring that no dirt etc falls into the unit (see Fig.1).
3. Oil should be filled to level indicated in the diagram. If low, add hydraulic oil as required.
Maintenance and inspection:
The owner and/ or user must maintain and inspect the jack in
accordance with the manufacturer’s instructions.
SPECIFICATIONS
max.505mm
min.75mm
430mm
36
0m
m
16
0m
m
800
mm
Ja
ck w
ill
not
ho
ld l
oa
d
or
handle
ris
es
Ja
ck
will n
ot
lift
loa
d
PRO
BLE
MS
Ja
ck
will n
ot
lift
to
its
full
he
ight
Ja
ck
will
no
t lowe
r
co
mp
let
ely
Jack
wil
l n
ot
lift
sm
oot
hly
or
ja
ck
feels s
po
ng
y
Trouble Shooting Check List
The release valve is not closed.
Turn the valve clockwise tightly.
Low on oil.
Refill the jack to the correct level of oil.
The hydraulic system is filled with air.Open the
release valve,pump handle rapidly (4) full strokes to
purge air, close release valve.
Return spring is broken or linkages binding.
Repace spring if broken.Grease pivot shaft,oil all
lift arm linkages.
Discharge ball is not sealing hydraulic system and oil
may be dirty.Manually flush hydraulic system by
raising and lowering lift arm by hand.Open the release
valve,as required to raise and lower the lift
arm.Manually raise and lower lift arm.
Fig.1
max.505mm
min.75mm
430mm
36
0m
m
16
0m
m
800
mm
Low height...........................................................7.5cm
High height........................................................ 50.5cm
Saddle diameter................................................... 11cm
Handle length...................................................112.5cm
Base length.......................................................... 80cm
Chassis width....................................................... 36cm
All dimensions are approximate.
